Negative Values for function Slots

Discussions, advice, bug reports and much more about the "bach" environment.
Post Reply
mtfirn
Posts: 1
Joined: Mon Sep 18, 2017 7:08 pm

Negative Values for function Slots

Post by mtfirn » Mon Sep 18, 2017 7:15 pm

Hi, I have been using Bach for a while and just started a project that is very spatiaIly notated and amusing the library's roll to do this. I am looking to have a function show up on the bottom of the duration line not the top or remove the diamonds/notes for a glissando to have one continuous line. Are either of these possible? I can make solid lines using a function slot but it does not scale to below zero or move along the y-axis.

danieleghisi
Site Admin
Posts: 1347
Joined: Fri Dec 03, 2010 1:25 pm

Re: Negative Values for function Slots

Post by danieleghisi » Tue Sep 19, 2017 5:59 pm

Hi,

unfortunately, currently, function background slots only extend above the duration lines.
Some more general improvement of background slots placement might be needed at some point, but it's a delicate and more general topic.

As for the pitch breakpoint function, currently you cannot remove the diamonds, but it shouldn't be too hard to create a display mode without diamonds. I'll mark it as a feature request, maybe it'll make the next release ;)

d

Post Reply